How to adjust the brakes on a bicycle? Process Features

Everyone who loves active life andcycling, must know how to adjust the brakes on the bike. The fact is that after a long ride the system can not work very well. So, let's consider when adjustment is needed. First of all, it is made in the event that the brakes are still new and have only been recently installed, or if the system has loosened up and just strikes the wheel without stopping it. If you notice that the bike stops too long, then it must also be inspected carefully.

If you do not know how to adjust the brakes forbicycle, you must first determine the type of system - vector, disk or tick-borne. Each of them has its own settings. The first two types are used most often, so we will talk about them.

So, let's look at the disk system. Before adjusting the brakes on the bike, you should consider their device. On the left side on the bushing next to the spokes is a disk made of steel. To him from both sides are pressed brake pads. Between them and the disk there must be a gleam. Most often, you have to adjust the rotor with a hexagonal wrench. Now, you need to spin the wheel to determine if the pads are rubbing against the disk, if the system is not running. If it is necessary that the brake handle has a smaller stroke, then the hexagon in it must be screwed deeper. Now you need to adjust the wheel and tighten all the bolts. If, after checking the bike, you notice that the brakes are not fully tuned, adjust the rotor and pads again.

Before adjusting the brakes forbike, see if everything is all right with the chassis. It may be necessary to replace some details, for example, if the pads are broken. If they stand still, but even with a close fit the brake works poorly, try to degrease them. It is desirable that the pads are metal.

Bicycle brakes are very important, because theyprovide security and allow you to stop. Debugging of the system should be done very carefully. For example, rim brakes need to be adjusted as follows: turn the bicycle and turn the wheel with force. In doing so, pay attention to the position of the pads relative to the wheel. The rim should be located strictly in the middle between them. If the wheel is tilted, then it should be leveled, and also move the brake in the desired direction. The pads must be adjusted so that they do not hang over or touch the tires. The distance to the rim is adjusted by means of a bolt on the mantle.

The reason for the poor performance of the system may beunreliable tension of the cables. To do this, unscrew the fasteners, tighten them as much as possible and tighten. If you need a more fine-tuning, then you need to spend it while riding with the help of special controls, which are located on the handles.

Here in brief and all the information on how to set up the brakes on the bike. Be careful and careful. Good luck!

</ p>>